Werbung
3.
Any warranted part which is scheduled for
replacement as required maintenance in Sca-
nia's written instructions for maintenance
and use of the engine by owner shall be war-
ranted for the period of time prior to the first
scheduled replacement point for that part. If
the part fails prior to the first scheduled re-
placement, the part shall be repaired or re-
placed by the engine manufacturer according
to Subsection (4) below. Any such part re-
paired or replaced under warranty shall be
warranted for the remainder of the period
prior to the first scheduled replacement point
for the part.
4.
Repair or replacement of any warranted part
under the warranty provisions of this article
shall be performed at no charge to the owner
at a warranty station.
5.
Notwithstanding the provisions of Subsec-
tion (4) above, warranty services or repairs
shall be provided at all manufacturer distri-
bution centers that are franchised to serve the
subject engines.
6.
The owner shall not be charged for diagnos-
tic labor that leadsto the determination that a
warranted part is in fact defective, provided
that such diagnostic work is performed at a
warranty station.
7.
The engine manufacturer shall be liable for
damages to other engine components proxi-
mately caused by a failure under warranty of
any warranted part.
8.
Throughout the engine's warranty period de-
fined above, the engine manufacturer shall
maintain a supply of warranted parts suffi-
cient to meet the expected demand for such
parts.
9.
Any replacement part, as defined in Section
1900(b), Title 13 of the California Code of
Regulations, may be used in the performance
of any maintenance or repairs and must be
provided without charge to the owner. It is
not necessary for replacement parts to be the
same brand or by the same manufacturer as
the original part sold with the engine. Such
use shall not reduce the warranty obligations
of the engine manufacturer.
10.
Add-on or modified parts, as defined in Sec-
tion 1900(b), Title 13 of the California Code
of Regulations, that are not exempted by the
California Air Resources Board may not be
used. The use of any non-exempted add-on
or modified parts shall be grounds for disal-
lowing a warranty claim made in accordance
with this article. The engine manufacturer
OPM 100 de-DE
Scania Power Solutions engine warranty for industrial engines
shall not be liable under this article to war-
rant failures of warranted parts caused by the
use of a non-exempted add-on or modified
part.
11.
The Executive Officer of the California Air
Resources Board may request, and in such
case, the engine manufacturer shall provide,
any documents which describe that manufac-
turer's warranty procedures or policies.
Parts covered by the Warranty
The following is a list of parts considered to be
part of the Emission Control Systems covered by
the Emission Warranty for Scania industrial en-
gines which were built to conform to federal and
California emission control regulations:
1.
Fuel injection system.
2.
Air induction system.
3.
Exhaust manifold system.
4.
Smoke puff limiter (included in ECU).
5.
Oil filler cap.
6.
EGR system (when applicable):
a)
b)
7.
Exhaust brake (when applicable).
8.
NOx Sensoren:
a)
b)
9.
DOC (when applicable).
10.
SCR system:
a)
b)
c)
d)
e)
f)
g)
h)
i)
5
©
Scania CV AB 2023, Sweden
Cooler.
EGR valve.
NOx sensor, engine out.
NOx sensor, tail pipe.
DEF tank.
DEF tank level, temperature and quality
sensors.
DEF hose.
DEF injector.
DEF injector pressure and temperature
sensors.
Evaporator.
SCR catalyst inlet temperature sensor.
SCR catalyst including the ammonia-slip
catalyst.
SCR control unit (EEC3).
Werbung
