Marzocchi BOMBER Z1 COIL Bedienungsanleitung Seite 6

15 MM QUICK RELEASE INSTALLATION
1. Install the front wheel into the fork dropouts. Slide the axle through the non-drive side dropout and hub.
2. Open the axle lever fully and rotate the lever so it is engaged in the axle housing notch.
3. With the lever engaged in the notch, turn the axle clockwise 5-6 complete turns into the axle nut.
4. Adjust the axle tension by tightening the axle clockwise so that you start to feel resistance when closing
the QR lever 90 degrees away from full closure.
IMPORTANT: Once the lever is out of the axle housing notch, it can be rotated to the proper position of
1-20 mm in front of the fork.
5. Close the lever. The lever must have enough tension to leave an imprint on your hand.
Use hand pressure only. Never use any tool to tighten the quick release lever. Over-tightening the
levers can damage the axle or fork dropouts, leading to a sudden failure with one or more of these
components, resulting in SEVERE INJURY OR DEATH. Conversely, failure to secure the axle properly,
including insufficient tension upon closing, can cause the wheel to become detached from the
bicycle, resulting in SEVERE INJURY OR DEATH.
KABOLT INSTALLATION
1. Install the front wheel into the fork dropouts. Slide the
Kabolt axle through the non-drive side dropout and hub.
2. Use a 6 mm hex wrench to torque the Kabolt
axle (clockwise) to 17 Nm (150 in-lb).
WARNING
6
1-20 mm