TR-Electronic sercos C-58 Serie Benutzerhandbuch Seite 97

7 Setting the Sercos address via the service channel
At present this function is not implemented.
The setting of the Sercos address via the service channel by means of IDN / S-0-1040 can only be
performed if the switch position is adjusted to 0x00, see chapter "Setting the Sercos address by means
of rotary switches" on page 76.
With write access on the service channel the new Sercos address is taken over and stored
permanently.
Parameter-Format, sercos address
name
attribute length (octet)
data type and display format
function
positions after decimal point
write protection
conversion factor
scaling / resolution of LSB
unit
minimum value
maximum value
scope of parameter
Printed in the Federal Republic of Germany
08/31/2017
sercos address
unsigned decimal
parameter
manufacturer-specific
TR - ECE - BA - DGB - 0105 - 03
2
0
1
1
n/a
1
255
local
 TR-Electronic GmbH 2013, All Rights Reserved
Page 97 of 103