TR-Electronic sercos C-58 Serie Benutzerhandbuch Seite 102

Error Causes and Remedies
9.2.5 Communication errors
This state is displayed by means of the Sercos-III-LED with flashing pattern # 13,
see Sercos-III-LED on page 84.
Communication errors refer to the Sercos communication profile (SCP) and report
either errors, warnings, procedure command - specific states or operational state
specific states.
The reports are very extensive. Thus, for the parameter IDN / S-0-0390 Diagnostic
number, the individual reports have to be taken from the Sercos specification.
For example: status code = 0x4002 (diagnosis class = 0xF for errors) means that the
connection was interrupted, because the data losses was too high.
9.2.6 Identification
This state is displayed by means of the Sercos-III-LED with flashing pattern # 14,
see Sercos-III-LED on page 84.
The message is triggered in case of a request for identification and serves for the
location of the appropriate device or for validation of the Sercos address. After request
the Sercos-III-LED flashes four seconds and the device sends an Identify
Response.
There are two ways for the identification request
1. by setting the bit 15 in the device control S-0-1044 Device Control (C-DEV)
2. or via the S/IP identify service, Message-Type = 94
9.2.7 Watchdog error
This state is displayed by means of the Sercos-III-LED with flashing pattern # 15,
see Sercos-III-LED on page 84.
The watchdog serves for the monitoring of the connection in the asynchronous mode
and is adjusted in the connection setup S-0-1050.0.01 Connection setup by means
of the bits 1-0 = 01 non-cyclic type 1.
The timeout for the watchdog results from the product
S-0-1050.0.10 Producer Cycle Time * S-0-1050.0.11 Allowed Data Losses
 TR-Electronic GmbH 2013, All Rights Reserved
Page 102 of 103 TR - ECE - BA - DGB - 0105 - 03
Printed in the Federal Republic of Germany
08/31/2017