Adjusting The Back Height; Installing The Anti-Tipper - Otto Bock Motus Bedienungsanleitung

6.10 Adjusting the Back Height (Fig. 46)
The back height is adjustable by 10 cm. The back tube which is integrated into the posterior
frame allows for the adjustment of the back height in increments of 2.5 cm.
For this purpose, remove the screws from the rear wheel adapter (fig. 46, see arrow) and set
the desired back height.
Make sure to firmly retighten all screws and nuts after making adjustments. The proper
INfORMATION
torque is 8 Nm�
6.11 Installing the Anti-tipper (Fig. 47 – 49)
1. Mount the receiver tube on the frame in the position as shown in the figure (fig. 47).
2. Screw the anti-tipper in the utmost position of the receiver tube as shown in the figure
(fig. 48).
3. Adjust the anti-tipper using the longitudinal adjustment (fig. 49).
4. By changing the screw connection in the receiver tube the anti-tipper can be horizontally
adjusted. The anti-tipper wheel must at least completely extend from the rear wheel to the
back, and the distance between the wheel and ground should not exceed 5 cm maximum.
Find the appropriate position with the assistance of a helper!
58
46
47
48