Installing The Cover; Installing The Dust Protection Ring; Installing The Swivel Arm; Mounting Of The Top Closure - struers ProntoPress-10 Gebrauchsanweisung

Installing the Cover

Installing the
Dust Protection Ring

Installing the Swivel Arm

Mounting of the Top Closure

Disassembling
the Mounting Unit

Removing the Swivel Arm

Descending the Lower Ram

Removing the
Dust Protection Ring
ProntoPress-10
Instruction Manual
Unscrew the fixation screw about 10 mm.
Place the mounting cylinder over the lower ram with the
fixation screw in the position shown.
Turn the mounting unit in a clockwise direction until it stops.
Tighten the fixation screw completely.
Mount the tube with the straight quick coupling on the lower
quick coupling of the mounting unit (pos. 4) and push to
connect. Make sure that the ring comes to stop in the extreme
end of the quick coupling.
Mount the tube with the elbow quick coupling on the upper
quick coupling of the mounting unit (pos. 3) and push to
connect. Make sure that the ring comes to stop in the extreme
end of the quick coupling.
Mount the plug (pos. 5) in the socket. Tighten the coupling nut.
Introduce the barb in the front of the opening for the cover.
Introduce the barbs on both sides of the cover in the cabinet.
Press the sides of the cabinet gently.
Press the rear end of the cover in so that the catch engages.
Place the dust protection ring around the mounting cylinder. The
concave side should face upwards.
Insert the rod in the hole at the top of the cover for the mounting
unit.
Introduce the top closure in the hole at the top of the swivel arm.
Lift the swivel arm out of the hole at the top of the cover for the
mounting unit.
Switch on the main power of the machine.
Press the key RAM DOWN
limit.
Lift up the dust protection ring.
Catch
N
to lower the ram to its lower
7