Mounting And Connection Of The Individual Units; Control Unit - struers Tenupol-3 Gebrauchsanweisung

Tenupol-3
Instruction Manual

1.3. Mounting and Connection of the Individual Units

1.3.1. Polishing Unit
Place the base plate with pump, polishing cell etc. on top of the insulated
PVC-reservoir. The cooling coil and the pump must be immersed in the
reservoir. The pump motor and polishing cell must turn upwards (see fig.
11).
Put the thermometer pocket in the drilled hole (Fig. 2.5) between the
polishing cell and the pump motor. Put the thermometer into the pocket.
Mount the two jet holders and the specimen holder as described in sections
OPERATION.
Connect the polishing unit to the control unit. Connect the multi plug to the
socket on the right hand side of the control unit and fasten the coupling nut
of the plug. The fastening is done by hand, without use of spanners or other
tools.
Connect the cooling coil to a separate cooling unit, to the water pipe, or to
some other cooling arrangement which meets all technical and safety
regulations as well as any possible restrictions on consumption of water
resources.
Alternatively, the uninsulated vessel can be used as electrolyte reservoir.
Thus, a cooling effect can be obtained if this reservoir is placed in an ice
bath or another cooling bath.
1.3.2.

Control Unit

On the left hand side of the instrument (Fig. 1.3) a mains voltage switch is
placed. Check that it is set according to the actual supply voltage.
The power cord supplied with the instrument is mounted in the
corresponding socket on the left hand side of the instrument (Fig. 1.4) and
then connected to the mains.
On the lower side of the instrument, approx. 5 cm from the front edge,
foldable legs (Fig. 1.5) are mounted at both sides. These legs can be used if
it is required that the front plate of the control unit should be more inclined.
5