struers ProntoPress-10 Gebrauchsanweisung Seite 51

Display/error
The top closure cannot be screwed
down completely.
The top closure can not be loosened. The top closure has not been turned
JAPANESE TEXTS
ProntoPress-10
Instruction Manual
Cause
Damage to the threaded connection
in the top closure or to the upper
ram.
Dirt in the threads on the top closure
and the mounting cylinder.
The disc for thermal insulation,
placed on the top of the upper ram,
has a larger diameter than the upper
ram.
¼ turn back before starting the
process.
Cured resin on the cylindrical surface
of the top ram.
Dirt in the threads in the top closure
The display can show the screen
texts in Japanese. When choosing a
European language in the
LANGUAGE menu, you might
accidentally press ENTER e at the
Japanese option.
Action
Remove the upper ram from the top
closure (see instructions in chapter
Maintenance). Try both the following
procedures to identify the problem:
Try to mount the top closure,
without the upper ram. If this is
not possible, call a Struers
service technician.
Try to insert the disconnected
upper ram into the mounting
cylinder. If this is not possible,
call a Struers service technician.
Clean the threads.
Use only a dry lubricant powder.
Call a Struers service technician.
To release the top closure:
Move the lower ram up and down
several times.
If this does not help:
-Put heating on for 1 min.
If this does not help:
- Set the force or pressure to zero.
- Set the heating time and cooling
time to 15 min.
- Complete a mounting process.
If this does not help:
- Remove the two handles on the top
closure.
- Remove the plastic cover from the
top closure (See Maintenance).
- Loosen the top closure with a fork
spanner.
To return to English or French texts,
just follow this procedure:
Press Esc until a long beep is
heard.
Press F1.
Press MENU mN four times.
Press ENTER e.
47