Technical Data - struers ProntoPress-10 Gebrauchsanweisung

Subject
Mounting Units
(Optional)
Compression
Preheating
Heating
Cooling
ProntoPress-10
Instruction Manual

8. Technical Data

Diameter
Force on piston rod
Pressure in mounting
cylinder
Temperature
Time
Temperature
Time
Rate
Time
Specifications
Metric/International
25, 30, 40, 50 mm
Preheating:
0-20 kN in steps of 5
kN
0-2000 kp in steps of
500 kp
Heating:
0 - 50 kN in steps of 5
kN
0 - 5000 kp in steps of
500 kp
The pressure range is
dependent on the
cylinder diameter:
Preheating:
0-10 to 40 MPa in
steps of 2.5 to 10 MPa
0-100 to 400 bar in
steps of 25 to100 bar
Heating:
0-25 to 100 MPa in
steps of 2.5 to 10 MPa
0-250 to 1000 bar in
steps of 25 to 100 bar
100 - 180 °C in steps of
10 °C
0:30 - 15:00 min in steps of 0:30 min
Process:
100 - 180 °C in steps of
10 °C
Manual heating:
30 - 60 °C in steps of
10 °C
0:30 - 15:00 min in steps of 0:30 min
Economy Intermittent flow: 20 % of full flow
Low Intermittent flow:
2% of full flow for first 3 minutes
Afterwards: 20% of full flow
High
0 - 15:00 min in steps of 0:30 min
US
1 ¼", 1½"
Preheating:
0 - 5000 Lbf in steps of
1000 Lbf
Heating:
0 - 12000 Lbf in steps
of 1000 Lbf
The pressure range is
dependent on the
cylinder diameter:
Preheating:
0-1500 to 6000 psi in
steps of 250 to1000 psi
Heating:
0-3750 to 15000 psi in
steps of 250 to 1000
psi
212 - 356 °F in steps of
18 °F
Process:
212 - 356 °F in steps of
18 °F
Manual heating:
86 - 140 °F in steps of
18 °F
Full flow
51