Selecting The Operating Mode - CLIVET MSAN 81 Anleitung Zur Installation, Bedienung Und Wartung

SELECTING THE OPERATING MODE

The operating mode is determined by the indoor unit. In fact, the voltage free contact on the indoor unit, suitably connected
to the heat pump circuit (see wiring diagram enclosed), is used to select cooling or heating operating mode.
Level 0
Control probe
Set Point : SEt
Alarm active
Analogical input: tP
Alarms: Err
Digital inputs: Id
Parameters: PAr
Password: PSS
Operating hours: OHr
To move around the levels press the "Mode" and "on off" buttons together.
1 - Pressing and releasing both buttons within 2 seconds goes down one level in the configuration
2 - Holding both buttons for more than 2 seconds goes up one level in the configuration menu.
3 - If the last level of a menu is displayed, pressing and releasing both buttons within 2 seconds
Level 1
menu.
goes back one level.
Level 2
Cooling Set Label: Coo
Input codes: t01- t06
Active alarm codes: E00-E46
Input codes: 01- 11
I I
Configuration par.: CnF
Compressor Par.: CP
Fan par.: FAn
Alarm par.: ALL
Punp par.: PUP
Antifreeze par: Fro
Antifreeze par: dFr
Password value
Comp. hours: OH1-OH2
Pump hours: OHP
51
Level 3
Cooling Set Value
Analogical input values
Digital input status
Par. index H01-H52
Par. index C01-C07
Par. index F01-F25
Par. index A01-A26
Par. index P01-P03
Par. index r01-r15
Par. index d01-d09
Number of hours
Number of hours
Level 4
Parameter value
Parameter value
Parameter value
Parameter value
Parameter value
Parameter value
Parameter value