Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The contents of this manual are designed to assure the correct installation, adjustment and maintenance of the unit; therefore:
- read the instructions with due care and attention;
- the unit must be installed, tested and serviced by properly qualified personnel (law no. 46, 5/3/1990) licensed in accordance
with established legislation.
• The manufacturer declines all liability, and warranty cover is automatically waived, if electrical and/or mechanical
modifications are made to the unit. Tampering and unauthorised repairs or modifications to the unit will automatically void the
warranty.
• Observe the safety regulations in force at the time of installation.
• Make sure that the characteristics of the mains network conform to the data on the serial number plate inside the electrical
panel.
• Keep this manual and the wiring diagram with care. Make sure that they are available for reference by the operator whenever
necessary.
• Packing materials (plastic bags, polystyrene foam, nails, etc.) are potentially hazardous and must be kept out of the reach of
children. Recycle packing materials in accordance with local standards.
• The condensing unit is designed for air-conditioning in combination with the indoor refrigerant expansion unit.
• Disconnect the unit in the case of breakdowns or malfunctions.
• If repairs are necessary, only use service centres that are authorised by the manufacturer and always insist on original spare
parts.
The use of non-original parts and/or unauthorised service centres may result in unsafe operation of the unit.
The manufacturer declines all liability for direct or indirect damage to property or injury
ADDITIONAL SAFETY PRECAUTIONS
This unit has been especially designed and manufactured so to prevent any risk to persons and health hazard.
For this reason, solutions designed to eliminate (where possible) any cause of risk and significantly reduce the probability of
danger have been adopted.
Please refer to the residual risks section of this manual and strictly observe the behaviour prescriptions listed there in order to
prevent any possible risks that have not been possible to avoid in the design stage.
ACCESSORIES
The unit can be fitted with the following accessories (on request):
─ voltages other than standard
─ coil protection grid
─ rubber base antivibration mounts
─ connection kit (which includes:)
thermostat
no return valve
liquid flow indicator
─ connection to remote control module
─ connection to PC or BMS
GENERAL WARNINGS
to persons resulting from failure to adhere to the instructions in this manual.
36
Werbung
Inhaltsverzeichnis
Fehlerbehebung
