WIKA CPT2500 Betriebsanleitung Seite 23

6. USB-ScanSoft software
Item Button
5
6
7
8
9
10
11
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft
Description
Load data
Loads a data logging that has already been made.
A new folder is created for each past data logging.
⇒
This function is only active when data logging is not in progress.
For further information, see chapter 6.3.9 "Load data".
Export data
Exports an image file with all curves and a .csv file per device. The .csv
file contains all measuring points of the area selected in the diagram.
The data exported in this way is located in the data directory of the
opened measured data.
⇒
This function is only active when data has been loaded.
For further information, see chapter 6.3.10 "Export data".
Zoom 1:1
By pressing the left mouse button, the desired area is marked and
enlarged (zoomed).
The [Zoom 1:1] button resets the zoom and displays the entire curve
area again.
⇒
This function is only active when data has been loaded and is
already zoomed.
Zoom back
Sets the zoom one level back.
⇒
This function is only active when data has been loaded and is
already zoomed.
System information
Displays the system information of the program.
Version
■
Driver version
■
Licence condition
■
etc.
■
"Chart" register
Settings and views of the charts
⇒
This function is only active during data logging.
For further information, see chapter 6.3.3 ""Chart" register".
"Device" register
Listing of all instruments and definition of the measuring conditions
For further information, see chapter 6.3.2 ""Device" register".
EN
23