Responsibility Of The Operator; Personnel Qualification - WIKA CPT2500 Betriebsanleitung

3. Safety
Interface adapter
Before using the instruments, check that there are no cracks or missing plastic parts
■
on the case. Pay particular attention to the insulation of the connectors.
Design the wiring particularly carefully when connecting to other devices (e.g. PC).
■
Under certain circumstances, internal connections in third-party devices (e.g. GND
EN
connected to the ground) can lead to impermissible voltages that could compromise
or even destroy the function of the devices themselves or a device connected to it.
Improper handling of the interface adapter can damage the adapter itself. It is also
■
possible that your connected instruments may be damaged.
Measuring mode
Select the proper function and correct measuring range for the measurement.
■
Always operate the USB pressure sensor within the defined pressure range.
■
Any use beyond or different to the intended use is considered as improper use.
Do not use this instrument in safety or emergency shutdown devices.

3.4 Responsibility of the operator

The instrument is used in the industrial sector. The operator is therefore responsible for
legal obligations regarding safety at work.
The safety instructions within these operating instructions, as well as the safety,
accident prevention and environmental protection regulations for the application area
must be maintained.
The operator is obliged to maintain the product label in a legible condition.

3.5 Personnel qualification

WARNING!
Risk of injury should qualification be insufficient
Improper handling can result in considerable injury and damage to property.
▶
Skilled personnel
Skilled personnel, authorised by the operator, are understood to be personnel
who, based on their technical training, knowledge of measurement and control
technology and on their experience and knowledge of country-specific regulations,
current standards and directives, are capable of carrying out the work described and
independently recognising potential hazards.
12
The activities described in these operating instructions may only be
carried out by skilled personnel who have the qualifications described
below.
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft