Usb-Scansoft Software; Intended Use; First Steps And Installation; Installing The Drivers - WIKA CPT2500 Betriebsanleitung

6. USB-ScanSoft software

6. USB-ScanSoft software
Personnel: Skilled personnel
EN For contact details, see chapter 1 "General information" or the back page of
the operating instructions.
This software is intended for use with the CPT2500 only. Several CPT2500 can be
read out and displayed simultaneously. The number of CPT2500 that can be used and
the display speed depend on the respective system. For more details, see the system
requirements.
After data logging, the data is saved to the disk and can be viewed and commented on
at any time.

6.1 Intended use

This operating instructions assumes basic knowledge of operating a PC under the
Windows™ operating system. If these are not available, it is recommended to familiarize
yourself with the basics of Windows™ before installation (manuals, technical literature,
introductory courses, etc.).
The software may only be used for its intended purpose.

6.2 First steps and installation

To use the software, the driver may need to be installed first.

6.2.1 Installing the drivers

A user account with administrator rights is required to install the device
drivers.
If you do not have these rights, log in with an appropriate account or ask
your system administrator.
Windows 2000, Windows XP and Windows Vista™ or Windows 7
If a device with the same USB chipset is already installed on your PC, the adapter will
automatically be installed when it is plugged in.
If this is not the case, you will be prompted to install the driver.
1. Insert the data medium with the driver into the drive.
2. Switch to the CD drive and select the directory with the driver data.
3. According to the operating system, start the installer for the driver from the data
medium.
⇒
CP210XVCPInstaller.exe
4. Follow the instructions of the installation program.
18 WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft