Determining The Driver Version Used; Checking The Correct Installation And Com Port - WIKA CPT2500 Betriebsanleitung

6. USB-ScanSoft software

6.2.4 Determining the driver version used

Two installed device drivers are required to use the adapter.
"USB-Composite Device" (for the USB device itself)
■
"USB to UART Bridge Controller" (for the preparation of the COM port)
■
EN
1. With the adapter plugged in, access the device manager.
⇒
Start \ Settings \ System control \ System \ Hardware
2. For the USB device driver open the sub-item "USB controller".
3. Then, by double-clicking, open the properties for the connection "CP210X USB
Composite Device".
4. Select the sub-item Driver.
5. For the COM driver, open the sub-item "Connections (COM and LPT)".
6. Then, by double-clicking, open the properties for the connection "CP210X USB to
UART Bridge Controller (COM x)".
⇒
Under the item Driver version, the currently
used driver version can be determined.

6.2.5 Checking the correct installation and COM port

Is the driver installed correctly?
■
Under which COM port can the newly installed adapter be addressed?
■
1. Access the device manager.
⇒
Start \ Settings \ System control \ System \ Hardware
2. Open the sub-item Connections (COM and LPT).
If the installation was successful, the entry "CP210x USB to UART Bridge Controller
(COM x)" will be displayed.
⇒
The x after the COM stands for the COM port that is now available (e.g. COM 4).
20
Currently used driver version
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft