Changing The Com Port Of The Adapter; Installing The Software - WIKA CPT2500 Betriebsanleitung

6. USB-ScanSoft software
The adapter must be connected to the PC for it to be displayed in the device
manager!
If the entry is marked with an exclamation mark or is not included, the driver has not
■
been installed correctly.

6.2.6 Changing the COM port of the adapter

1. With the adapter plugged in, access the device manager.
⇒
Start \ Settings \ System control \ System \ Hardware
2. Open the sub-item Connections (COM and LPT).
If the installation was successful, the entry "CP210x USB to UART Bridge Controller
(COM x)" will be displayed.
⇒
The x after the COM stands for the COM port that is now available (e.g. COM 4).
3. Open the properties for this connection by double-clicking.
4. Switch to Connection properties and select the item "Advanced".
⇒
Here you can now set the desired COM port under "COM port number".
If this port is already assigned to another device (even if it is not currently connected),
an error message appears:
Setting two devices on the same COM port is possible in principle, but it
must be ensured that both devices are not connected at the same time,
otherwise there will be a conflict!

6.2.7 Installing the software

1. Download the software from the website.
2. Open the zip file.
3. Open the x64 or x86 folder according to the system requirements.
4. For the German language installation, open the de-DE folder.
A new program group is created with the following program icon.
Double-click on this icon to start the software.
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft
EN
Scan
Soft
21