Transport, Packaging And Storage; Transport; Packaging And Storage; Interface Adapter - WIKA CPT2500 Betriebsanleitung

4. Transport, packaging and storage

4. Transport, packaging and storage

4.1 Transport

Check the instrument for any damage that may have been caused.
Obvious damage must be reported immediately.
EN
CAUTION!
Damage through improper transport
With improper transport, damage to property can occur.
▶
▶
If the instrument is transported from a cold into a warm environment, the formation of
condensation may result in instrument malfunction. Before putting it back into operation,
wait for the instrument temperature and the room temperature to equalise.

4.2 Packaging and storage

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature
Humidity
(non-condensing)
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
Store the instrument in its original packaging in a location that fulfils the conditions
listed above. If the original packaging is not available, pack and store the instrument as
described below:
1. Wrap the instrument in an anti-static plastic film.
2. Place the instrument, along with the shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag containing
a desiccant inside the packaging.
14
When unloading packed goods upon delivery as well as during internal
transport, proceed carefully and observe the symbols on the packaging.
With internal transport, observe the instructions in chapter
4.2 "Packaging and storage".
USB pressure sensor
model CPT2500
-40 ... +100 °C [-40 ... +212 °F]
0 ... 95 % r. h.
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft

Interface adapter

model CPA2500
-25 ... +70 °C [-13 ... +158 °F]
0 ... 95 % r. h.