Controls; Menu Bar - WIKA CPT2500 Betriebsanleitung

6. USB-ScanSoft software

6.3 Controls

6.3.1 Menu bar

The main functions are stored in the menu bar. Depending on the program state,
some of the menu items may be disabled. Clicking the left mouse button calls up the
respective function. By clicking the right mouse button, settings can be made.
EN
11
10
Item Button
1
2
3
4
22
1 2 3 4
Description
Language selection
The language can be changed while the program is running. During
a running data logging the selection is disabled. To change the
language easily, both the name of the language and the country flag
are displayed.
Start search
With the help of this search function, a search of all instruments
connected to the system is carried out.
Here you can set the presetting for the instruments found. These are
identical for all instruments. It is not possible to differentiate here.
⇒
This function is only active when data logging is not in progress.
⇒
For further information, see chapter 6.3.6 "Start search".
Start recording
With the help of this function, the measurement is started and
measuring results are saved automatically.
The active CPT2500 are selected before in the "Device" register.
⇒
This function is only active when data logging is not in progress.
For further information, see chapter 6.3.7 "Start recording".
Stop recording
This function is used to stop the current measurement. The data stored
up to that point is retained.
⇒
This function is only active during data logging.
For further information, see chapter 6.3.8 "Stop recording".
WIKA operating instructions, models CPT2500, CPA2500 and USB-ScanSoft
5 6 7 8 9