Stryker ProCuity-Serie Bedienungsanleitung Seite 27

F F i i g g u u r r e e 1 1 0 0 – – A A p p p p l l y y i i n n g g S S t t e e e e r r - - L L o o c c k k
T T r r a a n n s s p p o o r r t t i i n n g g t t h h e e p p r r o o d d u u c c t t w w i i t t h h Z Z o o o o m m d d r r i i v v e e o o p p t t i i o o n n
W W A A R R N N I I N N G G
• Always store the power cord before you transport the product.
• Always lock the siderails in the full up position with the sleep surface horizontal when you transport a patient.
• Always keep limbs, hands, fingers, and other body parts clear of mechanisms and gaps.
• Always check that there are no obstacles near the product. Injury to the patient, operator, bystanders or damage to the
frame or surrounding equipment could occur if you collide with an obstacle.
• Do not attempt to transport the product laterally after you apply the Z Z o o o o m m motorized drive. The Z Z o o o o m m motorized drive
cannot swivel.
• Do not use the brake to slow or stop the product while it is in motion.
C C A A U U T T I I O O N N
• Always remove the patient helper before you transport the product.
• Always make sure that the IV pole is at a low height during transport.
• Do not transport the product on inclines greater than 6 degrees (10% grade).
P P r r o o C C u u i i t t y y may be equipped with a Z Z o o o o m m motorized drive. The Z Z o o o o m m motorized drive provides mobility and efficient
transport of the product.
To transport the product with Z Z o o o o m m :
1. Lock the siderail control panel functions ( Footboard control panel - Motion lock (page 47)).
2. Unplug the power cord from the wall outlet.
3. See Storing the power cord (page 20).
4. Lower the IV pole ( Raising or lowering the H H A A V V A A S S U U IV pole option (page 63)).
5. Turn the oxygen bottle holder in toward the product.
6. Raise and lock the siderails in the full up position ( Raising the siderails (page 29)).
7. Release the brakes ( Applying or releasing the brakes (page 21)).
8. Raise the Z Z o o o o m m handles to the upright position ( Raising or lowering the Z Z o o o o m m handles option (page 25)).
9. Adjust bed height.
10. Grasp and hold both handles (Figure 12).
3009-009-005 Rev AD.2
F F i i g g u u r r e e 1 1 1 1 – – R R e e l l e e a a s s i i n n g g S S t t e e e e r r - - L L o o c c k k / / n n e e u u t t r r a a l l p p o o s s i i t t i i o o n n
23 EN