Stryker ProCuity-Serie Bedienungsanleitung Seite 25

T T r r a a n n s s p p o o r r t t i i n n g g t t h h e e p p r r o o d d u u c c t t
W W A A R R N N I I N N G G
• Always use two people when you transport the product.
• Always store the power cord before you transport the product.
• Always lock the siderails in the full up position with the sleep surface horizontal when you transport a patient.
• Always keep limbs, hands, fingers, and other body parts clear of mechanisms and gaps.
• Always check that there are no obstacles near the product. Injury to the patient, operator, bystanders or damage to the
frame or surrounding equipment could occur if you collide with an obstacle.
• Do not attempt to transport the product laterally. This may cause the product to tip.
C C A A U U T T I I O O N N
• Do not use the siderails as a push or pull device. Always move the product using the integrated handles in the
headboard and footboard.
• Always remove the patient helper before you transport the product.
• Do not use the patient helper as a push or pull device.
• Do not use the oxygen bottle holder as a push or pull device.
• Do not use the IV pole as a push or pull device.
• Always make sure that the IV pole is at a low height during transport.
To transport the product:
1. Lock the siderail control panel functions ( Footboard control panel - Motion lock (page 47)).
2. Unplug the power cord from the wall outlet.
3. See Storing the power cord (page 20).
4. Lower the IV pole ( Raising or lowering the H H A A V V A A S S U U IV pole option (page 63)).
5. Turn the oxygen bottle holder in toward the product.
6. Raise and lock the siderails in the full up position ( Raising the siderails (page 29)).
7. Release the brakes ( Applying or releasing the brakes (page 21)).
8. Push the product from the headboard or footboard.
A A p p p p l l y y i i n n g g o o r r r r e e l l e e a a s s i i n n g g t t h h e e b b r r a a k k e e s s
W W A A R R N N I I N N G G
• Always apply the brakes when a patient is getting into or out of the product to avoid instability.
• Always apply the brakes when the patient is unattended.
• Do not apply the brakes to slow or stop the product while the product is in motion.
The brake pedal is at both the head end and foot end of the product.
To apply the brakes, depress the red side of the pedal (Figure 8). The brake pedal locks all four casters to hold the product
in place.
To release the brakes, depress the green side of the pedal until the pedal is in the neutral position (Figure 9). This releases
all four casters and allows you to move the product.
To apply or release the brakes with the electric brake option, press B B r r a a k k e e on the operator control panel ( Operator control
panel, advanced, outside siderail option (page 39)) or press B B r r a a k k e e on the footboard control panel ( Footboard control panel
- Home (page 44)).
N N o o t t e e - - The B B r r a a k k e e icon on the operator control panel ( Operator control panel, basic, outside siderail (page 38), Operator
control panel, advanced, outside siderail option (page 39)) and the B B r r a a k k e e icon on the footboard control panel ( Footboard
control panel - Home (page 44)) illuminates when you release the brakes.
3009-009-005 Rev AD.2 21 EN