Stryker ProCuity-Serie Bedienungsanleitung Seite 16

Customer network communication requirements for i i B B e e d d W W i i r r e e l l e e s s s s option:
L L A A N N e e n n v v i i r r o o n n m m e e n n t t
Client/server communication
Client device IP allocation
Server IP allocation
VLAN
I I P P t t r r a a f f f f i i c c e e n n v v i i r r o o n n m m e e n n t t
S S o o u u r r c c e e
i i B B e e d d Server
i i B B e e d d W W i i r r e e l l e e s s s s Client
C C u u s s t t o o m m e e r r W W L L A A N N e e n n v v i i r r o o n n m m e e n n t t
Supported wireless vendors
Access point (AP) types
Channel width
Channel utilization
Signal strength range (minimum)
Minimum SNR
Priority queuing
Client exclusion
Client load balancing
Max number of SSIDs
EN 12
IPv4 only
Static
DHCP
Static IP required
New, existing
P P r r o o t t o o c c o o l l / / P P o o r r t t n n u u m m b b e e r r
TCP/443
TCP/443
Cisco, Aruba
Controller-based or autonomous
2.4 GHz: 20 MHz
5 GHz: 20/40 MHz
Consistently less than 30%
2.4 GHz: -67dBm +0/-8dBm
5 GHz: -67dBm +0/-8dBm
Minimum 20dB
Prioritized over best effort traffic
Disabled
Disabled
5
Not applicable
• If Static - Unique IP address will be
required for each client MAC
address
• If DHCP and not using a DNS
name - Each client MAC address
will need a reserved IP address
• If DHCP and using a DNS name - It
is required to create a unique name
for each client MAC address for
client management
∘ Stryker recommends using the
Stryker client host name when
the Stryker device connects to
the wireless network - Example:
SYK-00197b12365 so it may
look like http://SYK-
00197b12365.hosp.org
Not applicable
Install i i B B e e d d W W i i r r e e l l e e s s s s on a separate
VLAN
D D e e s s t t i i n n a a t t i i o o n n
i i B B e e d d W W i i r r e e l l e e s s s s Client
i i B B e e d d Server
Required
Required
Required
Recommended
Required
Required
Recommended
Recommended
Recommended
Recommended
3009-009-005 Rev AD.2