Possible Dangers Caused By The Drill Bit Grinder; Qualification Of The Staff; Target Group - Optimum OPTIgrind GH 10T Betriebsanleitung

We imperatively point out that due to any
constructive, technical or process control modifications which are not authorized by Optimum
Maschinen Germany GmbH the warranty will also be come null and void.
It is also part of intended use that you
observe the operating values and setting data of the drill bit grinder,

observe the operating instructions,

observe the inspection and maintenance instructions.


Technical data on page 42
1.4

Possible dangers caused by the drill bit grinder

The drill bit grinder is state-of-the-art.
Nevertheless, there is a residual risk as the drill bit grinder operates with
at high speeds,

rotating parts,

with an abrasive wheel (flying sparks)

with electrical voltages and currents.

We have used construction resources and safety techniques to minimize the health risk for the
staff resulting from these hazards.
If the drill bit grinder is used and maintained by the staff who are not duly qualified, there may
be a risk resulting from incorrect or unsuitable maintenance of the drill bit grinder.
INFORMATION
All staff involved in assembly, commissioning, operation and maintenance, must
be duly qualified,

strictly follow these operating instructions.

In the event of intended use
there may be a risk to the persons,

there may be a risk to the drill bit grinder and other material values,

the correct function of the drill bit grinder may be affected.

Always disconnect the mains plug from the socket before performing any cleaning or
maintenance works.
1.5

Qualification of the staff

1.5.1

Target group

This manual is addressed to
the operating companies,

the operators,

the staff for maintenance works.

Therefore, the warning notes refer to both, operation and maintenance staff of the drill bit
grinder.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
The qualifications of the staff for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond the
EN
GH 10T | GH 15T
38 Originalbetriebsanleitung
Safety
Version 1.1.4 - 2022-09-23