Technical Data - Kärcher B 260 RI Bp Dose+SB+R100 Bedienungsanleitung

Fault
Brake Damaged!
Engine Too Hot! Cool-down period
Horn Damaged!
Master Module Too Hot! Cool-down
period
Brush Drive Overload!
Fault
The device cannot be started
The water quantity is insufficient
The suction performance is too low
The cleaning results are unsatisfacto-
ry
The brushes do not rotate
The optional all-round light and/or the
working light do not light up
Fault
The device does not sweep properly 1. Check the roller brush and the side brushes for wear, replace if necessary.
The sweeping mechanism creates a
dust cloud
The cleaning result when sweeping in
the edge area is unsatisfactory
General
Travel speed (max.)
Transport speed
Reverse speed
Permissible braking distance on level ground at max.
travel speed of 10 km/h
Application time depending on brush head, brush con-
tact pressure and roughness of the ground
Theoretical surface coverage
Theoretical surface coverage with side scrubbing deck m
Theoretical surface coverage with 2 side brushes
Practical surface coverage with brush head
Fresh/waste water tank volume
Coarse dirt container capacity
Detergent tank (Dose option)
Detergent dosing range (from - to)
Minimum water dosing quantity
Maximum water dosing quantity
Max. surface pressure (incl. driver, water)
Rectification
1. Stop driving the device.
2. Contact Customer Service
1. Set the safety switch to "0".
2. Allow the device to cool down for at least 15 minutes.
3. Contact Customer Service if this occurs repeatedly
1. Contact customer service.
1. Set the safety switch to "0".
2. Allow the controller to cool down for at least 5 minutes.
3. Significantly reduce the brush pressure on rough ground.
4. Contact Customer Service if this occurs repeatedly.
1. Reduce the brush contact pressure.
2. Check if foreign objects (e.g. parcel tape, pieces of wood) are blocking the brushes.
Malfunctions without information shown on the display
Rectification
1. Insert the battery plug.
2. Turn the safety switch to "1".
3. Insert the Intelligent Key.
4. Check fuse F1, replace if necessary, (see chapter Replacing fuses).
5. Check the batteries and charge if necessary.
1. Check the fresh water filling level, if necessary fill the tank completely so that the air is pressed out.
2. Check the hoses for clogging and clean if necessary.
3. Remove and clean the fresh water filter.
4. Open the fresh water ball tap.
1. Close the lid on the waste water drain hose.
2. Clean the seals between the waste water tank and the cover, check for leaks and replace if necessary.
3. Clean the turbine filter.
4. Clean the suction lips at the suction bar, turn over or replace if necessary.
5. Check the suction hose for clogging and clean if necessary.
6. Check the suction hose for leaks and replace if necessary.
7. Check the adjustment of the suction bar.
1. Set the appropriate cleaning program for the cleaning task.
2. Use suitable brushes for the cleaning task.
3. Use a suitable detergent for the cleaning task.
4. Reduce the driving speed.
5. Adjust the contact pressure.
6. Adjust the squeegee blades.
7. Check the brushes for wear and replace if necessary.
8. Check the water output.
1. Reduce the contact pressure.
2. Check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
1. Check fuse F3, replace if necessary, (see chapter Replacing fuses).
Additional malfunctions on the Combo variant
Rectification
2. If the roller brush does not turn, check the drive belt, clean if necessary.
3. Check the function of the coarse dirt flap.
4. Check the sealing strips for wear, adjust or replace if necessary.
1. Empty the waste container.
2. Check the drive belts for the sweeping mechanism suction turbine.
3. Check the sealing sleeve on the suction fan.
4. Check the dust filter, clean or replace if necessary.
5. Check the filter box seal.
6. Check the sealing strip for wear, adjust or replace if necessary.
1. Check the height adjustment of the side brushes, adjust if necessary.
2. Replace the side brushes.

Technical data

B 260 RI
(R100)
km/h 10
km/h 10
km/h 6
m 1,9
h 5
2
m /h 10000
2
/h 11200
2
m /h 11500
2
m /h 7000
l 260
l 26
l 10
% 0-3
l/min 0,9
l/min 9
2
N/mm 1,33
B 260 RI B 260 RI
Combo (R100) (R 120)
10 10
10 10
6 6
1,9 1,9
4,5 5
10000 12000
--- ---
11500 13400
7000 8400
260 260
26 32
10 10
0-3 0-3
0,9 0,9
9 9
1,33 1,33
English
B 260 RI B 260 RI B 260 RI
Combo (R 120) (D100) Combo (D100)
10 10 10
10 10 10
6 6 6
1,9 1,9 1,9
4,5 5 4,5
12000 10000 10000
--- 11200 ---
13400 11500 11500
8400 7000 7000
260 260 260
32 0 0
10 10 10
0-3 0-3 0-3
0,9 0,9 0,9
9 9 9
1,33 1,33 1,33
25