Troubleshooting Guide; Warranty; Accessories; Technical Data - Kärcher BD 50/55 C Classic Bp Originalbetriebsanleitung

DANGER
Inadvertently starting up device
Risk of injury, electric shock
Turn the key-operated switch to "0" and remove the key
before performing any work on the device.
Malfunction
The device cannot be started
The water volume is insufficient
The suction performance is too low
The cleaning results are unsatisfacto-
ry
The suction turbine runs at an in-
creased speed
The brushes do not rotate
The device vibrates during cleaning
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
Description
Disc brush, complete red D51
Disc brush, (very soft)
Disc brush, (soft)
Disc brush, (medium soft)
Disc brush, (hard)
Pad drive board, 479 mm
Pad, 500 mm, (soft)
Pad, 508 mm, (soft)
Pad, 508 mm, (medium-soft)
Pad, 508 mm, (medium-hard)
Pad, 508 mm, (hard)
Diamond pad, 508 mm, (coarse)
Diamond pad, 508 mm, (medium)
Diamond pad, 508 mm, (fine)
Microfiber pad, 508 mm
Melamine pad, 508mm
Squeegee, 850mm
Suction lips, 33in, red
Suction lips, 33in, transparent
Device performance data
Nominal voltage
Battery capacity
Mean power input
Driving motor power
Suction turbine power
Brush drive power
Theoretical surface performance
Fresh water tank capacity
Waste water tank capacity

Troubleshooting guide

Pull out the charger mains plug.
 Drain and dispose of the waste water and fresh wa-
ter.
 Contact Customer Service in the case of malfunc-
tions that cannot be corrected using this table.
Rectification
1. Turn the key-operated switch to "1".
2. Actuate the safety switch.
3. Insert the battery plug.
4. Check the battery and charge if necessary.
5. Check that the battery terminals are correctly connected.
1. Check the fresh water filling level and fill the tank if necessary.
2. Increase the water volume at the water volume regulating knob.
3. Clean the fresh water filter.
4. Check the hoses for clogging and clean if necessary.
1. Shut down the device and drain the waste water.
2. Clean the seals between the waste water tank and the cover, check for leaks and replace if necessary.
3. Check that the suction hose is correctly connected to the waste water tank.
4. Check the fluff filter for soiling and clean if necessary.
5. Clean the suction lips at the suction bar, turn over or replace if necessary.
6. Check that the cap on the waste water drain hose is closed.
7. Check the adjustment of the suction bar.
8. Check the suction hose for clogging and clean if necessary.
9. Check the suction hose for leaks and replace if necessary.
1. Reduce the driving speed.
2. Check the brushes for wear and replace if necessary.
3. Check the suitability of the brush type and detergent used.
1. Drain the waste water.
2. Clean the float.
3. Check the fluff filter and clean if necessary.
4. Check the suction hose for clogging and clean if necessary.
5. Check the suction bar for clogging and remove any clogging if necessary
1. Check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
1. Use a softer brush.
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
Part no. Description
9.753-021.0 For general cleaning, for all surfaces.
4.905-028.0 For cleaning sensitive floors and polishing.
4.905-027.0 Made of natural fibers, for cleaning and polishing.
4.905-026.0 For general cleaning, for all surfaces.
4.905-029.0 For stubborn dirt and deep cleaning. Only for hard-wearing surfaces.
4.762-534.0 For cleaning with pads. With quick-change coupling and Centerlock.
6.371-146.0 With natural hair, for polishing. Removes scuff marks effectively.
6.369-468.0 Light grit, suitable for polishing floors.
6.369-079.0 For cleaning all types of floors.
6.369-078.0 For removing stubborn dirt and deep cleaning.
6.369-077.0 For cleaning heavily soiled floors and for deep cleaning.
6.371-260.0 For coarse cleaning / restoring. Removes small scratches, for a clean, silky matt surface. For sur-
face preparation prior to using the yellow pad. As a crystallization pad for basic crystallization.
6.371-261.0 For coarse cleaning / restoring. Removes fine scratches for a more homogenous and shinier sur-
face. For surface preparation prior to using the green diamond pad. As a crystallization pad for high-
gloss crystallization.
6.371-240.0 For effortless polishing of laminated floors, terrazzo, and natural stone surfaces. For maintenance
cleaning after using white and yellow pads.
6.371-271.0 Excellent cleaning power. Also effectively cleans fine stoneware tiles.
6.371-025.0 Melamine pad set for the effective cleaning of microporous surfaces.
4.778-008.0 Parabolic squeegee, Suction lips made of wear-resistant, red Linatex, with support rollers.
4.400-011.0 Made from Linatex, wear-resistant.
4.400-005.0 Made from PU, oil-resistant.

Technical data

Warranty

Accessories

BD 50/55 W Classic Bp
V 24
Ah (5 h) 80 / 115
W 880
W 130
W 250
W 500
2
m /h 2550
l 55
l 55
English
WARNING
Be careful when approaching blind corners, bushes,
trees or objects that might restrict your view.
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
BD 50/55 C Classic Bp
24
80 / 115
750
-
250
500
2040
55
55
15