12.3 Auxiliary channels "AUX1" and "AUX2"
Always make sure that the servos do not run against the stop when operating them. This means that the servos do
not strike mechanically in the respective end positions. Apart from increased power consumption, this also leads to an
overload of the servo gear or the servo electronics.
Keeping the "AUX1" button (fig. 1, no. 6) pressed activates the "AUX1" channel (fig. 2, item B) on the receiver.
The "AUX2" channel (fig. 2, item A) on the receiver has three different positions to be selected with the "AUX2"
slide switch.
43