Trim For The Drive Function, "Th-Trim" Knob; Dual Rate For The Drive Function, "Th-D/R" Knob; Drive Function Reversal, "Th" Slide Switch - Reely GY4 Bedienungsanleitung

10.10 Trim for the drive function, "TH-TRIM" knob

If the vehicle does not remain stationary when you release the throttle lever (middle/neutral position), set the trim for
the drive function accordingly using the "TH-TRIM" knob on the transmitter (fig. 1, no. 2).
During the adjustment, one of the LEDs (fig. 1, no. 13) indicates the trim position, and the LED
display changes back to the battery status if the knob is not moved for 5 seconds.
For a vehicle with an electronic speed controller, reconfigure the neutral and full throttle
positions if the trim path is insufficient. For a vehicle with a throttle/brake servo, make
sure to readjust the idle position via the corresponding control linkage.
When adjusting, ensure the neutral position of the drive roughly corresponds to the middle position of the
knob.

10.11 Dual rate for the drive function, "TH-D/R" knob

You can use this knob to set the control path for channel 2 (speed controller or throttle/brake servo).
You can also use this function to limit the maximum speed of a vehicle for a beginner. If an electronic speed controller
is connected to receiver channel 2, speed limitation means that only 50% of the motor power is available despite full
deflection on the throttle/brake lever.
During the adjustment, one of the LEDs (fig. 1, no. 13) indicates the setting, and the LED display
changes back to the battery status if the knob is not moved for approx. 5 seconds.
Please note:
If you turn the knob all the way to the left (counter-clockwise), you may not be able to
move the drive.

10.12 Drive function reversal, "TH" slide switch

Normally, pulling the throttle lever towards the handle on the transmitter causes the vehicle to move forward. Other-
wise, use the "TH" slide switch (fig. 1, no. 15) to reverse the movement direction of the drive.
Please note:
If the vehicle moves in the wrong direction after unplugging the electric motor from the speed controller
(e.g. for vehicle repair), reconnect the motor cables correctly instead of operating the slide switch (for
brushless motors, swap two of the three cables to reverse the direction of travel).
37