7.2
Operation
If you do not have sufficient knowledge of how to operate remote-controlled models, contact an experienced
model user or a model club.
Before connecting a rechargeable battery to a model, place the model on a suitable surface. Do not touch rotating
parts of the model while connecting the rechargeable battery. There is a risk of injury! For a car model, a surface
should be selected that allows the wheels to rotate freely. Do not hold the car model by the wheels.
When putting the device into operation, always switch on the transmitter first. Only then turn on the power supply
for the receiver in the model. Otherwise, the model may show unpredictable reactions.
Before using the model, check whether it responds properly to the remote control commands.
When operating a model, always make sure that body parts or objects are kept clear of the danger area of motors
or other rotating driving parts.
Improper use can cause serious injury and damage to property! Always keep the model in your line of sight and
never operate it at night.
Do not use the model if your responsiveness is impaired. Fatigue, alcohol and certain medications can affect your
responsiveness.
Never use the model in an area that may endanger other people, animals or objects. Only operate it on private
sites or places which are specifically designated for remote-controlled models.
In the event of a malfunction, discontinue use immediately and establish the cause of the problem before using
the model again.
Do not use the remote control during thunderstorms, under high-voltage power lines or in the proximity of radio
masts.
Always leave the remote control turned on when the model is in use. When turning off the model, always turn off
the motor first and then switch off the receiver system. Only then may the transmitter be turned off.
Protect the remote control from moisture and heavy soiling.
Do not expose the remote control to direct sunlight or excessive heat for prolonged periods.
The transmitter range decreases as the batteries get weaker. As the receiver batteries (the receiver rechargeable
battery or the drive battery that supplies the receiver of the speed controller with BEC) become weak, the model
fails to respond correctly to the remote control commands.
If this is the case, discontinue using the model immediately. Then replace the batteries with new ones or recharge
the receiver/drive battery.
Do not take any risks when using the product! Always use the model responsibly; otherwise, you may endanger
yourself and your surroundings.
30