Clamping The Workpieces; Removing Blockages; Cleaning And Maintenance; Cleaning - Parkside PTBM 400 B1 Originalbetriebsanleitung

GB
Caution! Fold the protective
device (23) down before you
switch on the machine.
Switching on:
1.. Press the On switch (27).
Switching off:
1. Press the Off switch (26).
Emergency stop:
Press the emergency stop button (24).
After actuating the emergency stop,
press the on switch (27) to start the
device again.

Clamping the Workpieces

Only work on workpieces that can be
securely clamped between the chuck jaws
(14). The workpiece must not yield too
much. Otherwise it is nor possible to apply
adequate tension.
The workpiece must not be too small or too
large either.

Removing Blockages

- You should always select a suitable
feed rate which allows trouble-free chip
breaking.
- If the bit is jammed in the workpiece,
turn off the power and unplug the pow-
er cord. Turn the bit on the drill chuck
anticlockwise with a little jerk to break
the chip and release the bit again.
- If a fragment is produced during the
processing of the workpiece, turn off the
power and unplug the power cord. Use a
pair of pliers and remove the fragment to
prevent it flying off in an uncontrolled way.
34
Cleaning and
maintenance
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it
for obvious defects such as loose, worn or
damaged parts, correct the positioning of
screws or other parts. Exchange the dam-
aged parts.

Cleaning

Do not use any cleaning agents or
solvents. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Remove chips, dust and dirt with a
vacuum cleaner if necessary.
• Lubricate moving parts regularly.
• Do not allow lubricants to come into
contact with switches, V-belts, pulleys
and drill lifting arms.