Technical Data; Notes On Safety - Parkside PTBM 400 B1 Originalbetriebsanleitung

28 Depth stop with scale
29 Locking screw of the depth stop
30 Drill chuck key
31 Allen key
32 On/off switch for laser
33 Mounting screw, laser
D
34 V-belt
F
35 Spindle-side drive pulley
36 Motor side drive pulley
37 Interlock switch

Technical Data

Bench Pillar Drill ....... PTBM 400 B1
Rated input voltage U .......230 V~, 50 Hz
Idle power consumption P
Power input .............. 400 W (S6 40 %)*
Idling speed (n )
0
Spindle ......................600 - 2650 min
Motor ................................ 1400 min
Safety class .......................................... I
Protection category...........................IPX0
Weight (with accessories) ............ 14.1 kg
Drill chuck ...........B16 (1.5 mm to 13 mm)
Spindle stroke .............................. 50 mm
Workpiece size .................... max. 60 mm
Laser
Laser class ........................................ 2
Laser wavelength .....................650 nm
Laser power P ........................< 1 mW
0
Power supply
Laser module ..... 2 x 1.5 V Micro (AAA)
Battery .................. Alkaline manganese
Sound pressure level
) ....................... 75.8 dB; K
(L
pA
Sound power level (L
measured .............. 88.8 dB; K
* After an uninterrupted operating time of 4
minutes under load, the device must then cool
down for 6 minutes in idle mode, otherwise
overheating would occur.
.....350 W (S1)
0
= 3 dB
pA
)
WA
= 3 dB
WA
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
Wear ear protection
The specified noise emission value has
been measured according to a standard-
ised testing method and may be used for
comparison with another power tool.
The specified noise emission value can
also be used for a provisional assessment
of the load.
Warning:
The noise emissions may deviate
from the specified values during ac-
tual use of the power tool, depend-
ing on how the power tool is being
used and, in particular, what kind
of material is being worked on.
-1
-1 Safety measures for protection of
the operator are to be determined
that are based on an estimate of
the load under the real operating
conditions.

Notes on safety

Caution! When using power tools,
observe the following basic safety
measures for the prevention of
electric shocks and the risk of injury
and fire.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.
GB
25