Service; Appliance-Specific Safety Instructions For Impact Wrenches; Setting Up; Switching On And Off - Parkside PDSSE 550 A1 Originalbetriebsanleitung

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .
Appliance-specific safety instructions
for impact wrenches
■ Wear hearing protection when impact screw-
ing. Exposure to loud noise can lead to hearing
loss .
■ Secure the workpiece. A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand .
■ Hold the power tool firmly. High torques can
occur for brief periods while tightening and
loosening screws .
■ Wait until the power tool has come to a
standstill before putting it down. The tool
could catch in something and thus lead to loss
of control of the power tool .
■ Hold the power tool by insulated gripping sur-
faces, when performing an operation where
the fastener may contact hidden wiring. Fasten-
ers contacting a "live" wire may make exposed
metal parts of the power tool "live" and could
give the operator an electric shock .
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person .
ATTENTION!
Hot surface .
There is a risk of burns .
PDSSE 550 A1

Setting up

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on
the appliance .

Switching on and off

Switching on:
♦ Press the ON/OFF switch
ance .
The appliance starts at maximum speed .
■ The tightening torque depends on the impact
duration .
Switching off:
♦ Release the ON/OFF switch
appliance .
ATTENTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!

Changing the direction of rotation

WARNING!
► The rotation direction switch
used/adjusted when the appliance is at a
standstill .
♦ Change the direction of rotation by pressing
the rotation direction switch
or right .
NOTE
► In clockwise rotation, the maximum torque is
limited to 100 Nm .

Fitting a socket

♦ Push one of the supplied sockets
tool holder .
to start the appli-
to switch off the
may only be
towards the left
onto the
GB │ IE │ 15 ■