Product Setup; Assembling The Product; Attaching The Adjusting Screw; Initial Use - Parkside PSG 85 A1 Originalbetriebsanleitung

Ensure you will have adequate space to
work in and will not put others at risk.
Always secure the product to the worktop
with screws of an adequate length and
thickness to always maintain control over
the product.
Product setup (see Fig. B)
- Required thickness of the edge of the table:
15–30 mm
- Drill diameter: 10.5 mm
- Size of screw: M10
Use the stop notches
uct on the worktop
must extend beyond the edge of the table.
Mark the bores with a pencil and remove
the product.
Now drill two holes in the worktop
Fasten the grinding base to the worktop us-
ing the included screws
and nuts .
24b

Assembling the product

(see Fig. C)
Screw the handle
head .
2
Loosen the locking nut
sioner .
12
Attach the chain tensioner
ing base and tighten with the locking
8
nut .
10
If applicable, attach the mains cable
inside the cable holder
Attaching the adjusting
screw (see Fig. C)
Before assembly, loosen the locknut
the adjusting screw
to the grinding head
26
adjusting screw
6
locknut .
26
10 GB/CY
to position the prod-
9
. The grinding base
22
.
22
, washers
23 24a
to the grinding
4
on the chain ten-
10
to the grind-
12
17
.
16
from
26
. Insert the locknut
6
and screw the
2
and washer to the
25

Initial use

CAUTION! RISK OF INJURY!
Only use grinding discs and accessories
recommended by the manufacturer. Using
tools or accessories other than those recom-
mended in the instructions for use could
result in injury.
Never operate the product without visual
cover.
Do not use saw blades.
Always unplug from the mains before work-
ing on the product.
Inspect the grinding disc prior to use: Check
the clearance between the visual cover and
grinding disc.
8
Do not use damaged or deformed grinding
discs.
Do not switch on the product until it has
been firmly secured to the worktop.
CAUTION! RISK OF INJURY!
Wear eye and hearing protection.
Wear cut-resistant safety gloves
and, if necessary, an apron
when working on the saw chain
to prevent cuts.
Keep your hands away from the
grinding disc and cutting teeth
during use. Do not move the saw
chain by hand. Risk of injury.

Switching on and off

Note: Verify the voltage specified on the
nameplate corresponds with the voltage of the
power source.
Note: Perform a test run of at least 30 seconds
without load before using this product for the
first time and after changing the grinding disc.
Switch off the product immediately if the grind-
ing disc is out of round, considerable vibration
occurs or you notice abnormal noise.
Plug the mains cable into a
socket (note the mains voltage).