Operation; Risk Of Injury; Setting Up; Selecting The Speed - Parkside PTBM 400 B1 Originalbetriebsanleitung

Make sure that the battery
compartment (
side of the hand spindle guide
( 25).
8. Put the safety device (23) on the
upper part of the drill spindle
(20).
9. Secure the safety device (23)
with the clamping screw (19).
10. Fold the safety device (23) up-
wards. Insert the chuck (21) on
the taper of the drill spindle (20).
Push the drill chuck (21) onto the
drill chuck tip with a few light
taps. Use a plastic hammer for
this purpose.

Operation

Caution!

Risk of injury!

- Ensure that you have sufficient space
in which to work and that you do not
endanger other people.
- All hoods and protective devices must
be assembled properly before commis-
sioning.
- Disconnect the mains plug before
changing the setting on the device.

Setting up

Place the bench drill on a solid surface.
Bolt the machine to the substrate before
putting into operation. Use the four holes
in the baseplate (9) for this.
F

Selecting the speed

1. Release the locking bolt (3) on the gear
cover.
2. Open the gear cover (1).
3. Loosen the two locking nuts (4) of the
17) is on the
Ø (mm):
motor unit (5) with an open-ended
spanner (size 14 mm, not included in
delivery).
4. Push the motor unit (5) a little towards the
column tube (6) to relieve the V-belt (34).
5. Place the V-belt (34) on the desired
combination to reach the specified
speed:
(U/min):
6. Tighten the locking nuts (4) again and
tension the V-belt (34) so that the motor
unit (5) presses backwards.
The V-belt (34) is correctly tensioned
when it can be pushed in about 1 cm.
7. Close the gear cover (1). Fasten the
locking bolt (3) on the gear cover .
The gear cover (1) is equipped with
a interlock switch (37). If the gear
cover (1) is not closed correctly, the
device cannot be switched on.
Recommended speeds for
different drill sizes and materials:
[mm]
< 3
3 - 4
5
6 - 8
> 8
2650
1800
1300
900
600
[mm] [1/min]
< 4
2650
5 - 6 1800
7 - 8 1300
9 - 10 900
> 10
600
GB
31