Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Changing The Die Holder Position (See Fig. A); Permissible Material Thickness - Parkside PMKA 20-Li A1 Originalbetriebsanleitung

CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
defective.
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.

Inserting/removing the battery pack

Inserting the battery pack
♦ Push the battery pack
clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
WARNING! RISK OF INJURY!
► Before doing any work on the device, switch
it off and remove the battery.
Changing the die holder position
(see fig. A)
The die position can be adjusted by 360°. Four
working positions offset by 90° are specified.
The working positions can be set as follows:
♦ Undo the hex screw
supplied.
♦ Turn the die holder
position so that the respective hole in the die
holder faces towards the hex screw
■ 8 │ GB │ IE
flashes, this means
has overheated and
both
is
into the appliance.
into the handle until it
and remove the
to
as follows:
using the hex key
into the desired working
.
♦ Retighten the hex screw
hex key .
♦ Rotate the die holder
whether it is fixed in the correct position.

Permissible material thickness

The maximum cutting capacity depends on the
material quality and strength. The measuring
grooves and on the die holder
a thickness gauge for the permissible cutting thick-
ness. Never cut material thicknesses greater than
those specified in the technical data.
Fitting and removing the grooved pin
and the die holder (see figs. B + C)
♦ To remove the grooved pin
holder , undo the hex screw
supplied hex key
♦ Pull the die holder
♦ Undo the hex screw
key so you can remove the grooved pin
from the tool holder
♦ Insert the new supplied grooved pin
tool holder so that the hole in the grooved
pin is facing towards the hex screw
♦ Tighten the hex screw
pin in place.
♦ Guide and replace the die holder
the tool holder in the appliance.
♦ Turn the die holder
position so that the respective hole in the die
holder faces towards the hex screw
♦ Retighten the hex screw
hex key .
♦ Rotate the die holder
whether it is fixed in the correct position.
using the supplied
slightly to check
serve as
and the die
using the
.
from the appliance.
using the supplied hex
.
into the
.
, to fasten the grooved
above
into the desired working
.
using the supplied
slightly to check
PMKA 20-Li A1