Werbung
Technical Instructions
Fig. 12
Setting of tightening torque - AT-versions
Ref. No. 160
–
+
Note
In most cases the factory settings give best performance.
Only experienced users should adjust the AutoTrim valve.
30
Start
Set the tightening torque
Check the tightening
on your actual joint
A - Torque level
B - Switching from reduced
to full power after
1-2 pulses
C - Min. 3-5 pulses
OK
Put the machine in operation
Atlas Copco Tools - No. 9836 1682 03
–
+
Not OK
Back to start
Not OK
Advanced
setting of
AutoTrim valve
Not OK
Fig. 15-17
EP5/6PTS HRX-AT
Werbung
