Standard Scope Of Delivery; Installation Requirements; Fixing - Optimum OPTidrill DQ 14 Betriebsanleitung

3.3.1 Standard scope of delivery

Bench drill DQ 14
- Drill chuck B16 for drills 0 to 13mm
Bench drill DQ 18
- Drill chuck B16 for drills 0 to 15.9mm
- Morse taper MT2 / B16
Bench drill DQ 22
- Drill chuck B16 for drills 0 to 16mm
- Morse taper MT2 / B16
3.4

Installation requirements

Organise the working area around the machine according to the local safety regulations. The
work area for operation, maintenance and repair must not be restrictive.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights (available as
an option) must be used.
Follow the prescribed safety areas and escape routes according to VDE 0100 part 729 as

well as the environmental conditions for the operation of the machine.
The mains plug or the main switch of the machine installed by the operator must be freely

accessible.
The machine must only be installed and operated in a dry and well-ventilated place.

Avoid places near machines generating chips or dust.

The installation site must be free from vibrations also at a distance of presses, planing

machines, etc.
Provide sufficient space for the personnel preparing and operating the machine and trans-

porting the material.
Also make sure the machine is accessible for setting and maintenance works.

3.4.1

Fixing

In order to provide for the necessary stability of the drilling machine, connect the machine with
its foot to the substructure.

Fix the foot of the drilling machine to the substructure with the holes pre-drilled for this pur-
pose.
ATTENTION!
Tighten the fixing screws of the drilling machine only as much that it is safely fixed and
cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand of the machine.
EN
DQ14 | DQ18 | DQ22
64 Translation of original instruction
Delivery, interdepartmental transport and unpacking
Version 1.0.3 - 2022-04-06