Maintenance; Safety; Preparation; Restarting - Optimum OPTidrill DQ 14 Betriebsanleitung

6

Maintenance

In this chapter you will find important information about
Inspection,

Maintenance and

Repair.

ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,

failure-free operation,

long service life of the machine and

the quality of the products which you manufacture.

Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
During work on the spindle head, please make sure that
collecting containers with sufficient capacity for the amount of liquid to be collected

are used.
liquids and oils should not be split on the ground.

Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current legal requirements on the environment.
Collect leakages
Do not re-introduce liquids spilt outside the system during repair or as a result of leakage from
the reserve tank; collect them in a collecting container for disposal.
Disposal
Never dump oil or other environmentally hazardous substances which are harmful to the envi-
ronment in water inlets, rivers or channels.
Used oils must be delivered to a collection centre. Please consult your supervisor for further
information on your nearest collection point.
6.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:
very serious injury to personnel working on the machine,

damage to the machine.

Only qualified personnel should carry out maintenance and repair work on the machine.
6.1.1

Preparation

WARNING!
Only work on the machine if it has been disconnected from the power supply.
Attach a warning sign which secures against unauthorized switching on.
6.1.2

Restarting

Before restarting, run a safety check.

Safety check on page 54
Maintenance
Version 1.0.3 - 2022-04-06 Translation of original instruction
DQ14 | DQ18 | DQ22 EN
77