Operation - Cameo P2 FC Bedienungsanleitung

OPERATION

NOTES
• As soon as the spotlight is correctly is connected to the power supply, the following will be
displayed in succession: "Welcome to Cameo", the model name and the software version. After
this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX modes or slave mode is enabled and there is no control signal at the DMX
input, the characters in the centre line of the display will start to flash.
• If no input is made within approximately 1 minute, the currently activated mode is automatical-
ly shown in the display (main display).
DISPLAY MAIN DISPLAY DMX MODE
The main display in DMX mode shows the currently set DMX start address, DMX mode and further
information (see illustration).
Currently activated operating mode
DMX start address and
Press encoder =
select mode (mode)
14
Status = DMX signal present
DMX | DMX
DMX Address 001
5CH RGBAL
DMX mode
Mode
= no DMX signal
Fan mode
| Auto
Menu
Press encoder =
Open main menu (Menu)