Cameo P2 FC Bedienungsanleitung Seite 15

SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press the right rotary-push encoder to enter the main menu. Ro-
tate the left encoder (SELECT) to select the menu item DMX Address (see left arrow) and confirm
by pushing the encoder (ENTER). You can now configure the DMX start address as required by ro-
tating the left encoder (the highest value depends on the selected DMX mode). At the same time,
the following DMX start address (following address) is displayed for the selected start address
plus channel number of the selected DMX mode. Confirm the entry by pressing the left encoder
(ENTER), which will also automatically return you to the main display and activate DMX mode. The
menu item for selecting the desired DMX mode can be reached directly from the DMX Address
menu item by pressing the middle rotary-push encoder (DMX mode); the previously set DMX start
address is automatically saved.
Rotate encoder =
change value
Press encoder =
confirm value change (Enter)
CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press the right rotary-push encoder to enter the main menu.
Rotate the left encoder (SELECT) to select the menu item DMX Mode (see left arrow) and confirm
by pushing the encoder (ENTER). You can now select the desired DMX mode by turning the left
encoder. Confirm the selection by pressing the left encoder (ENTER), which will also automatically
return you to the main display and activate DMX mode. Tables with the channel assignment of the
different DMX modes can be found in these instructions under DMX CONTROL.
DMX Mode
1CH DIM
2CH DIM 16Bit
2CH CCT
3CH RGB
5CH RGBAL
4CH CCT
6CH HSI-CCT
7CH RGB-CCT
11CH Direct CCT
10CH RGBAL 16Bit
10CH HSI-CCT
18CH Full Access
Menu
DMX Address
001 (5CH of Mode)
following Address 006
Enter DMX-Mode Menu
Press encoder =
select of DMX mode
Press encoder =
Open main menu (Menu)
15