Cameo P2 FC Bedienungsanleitung Seite 24

Colour = Colour calibration
Calibra- (for 3CH RGB and
tion 7CH RGB CCT
modes, only Smart
and Factory Calibra-
tion are available)
Autolock = Automatic locking of
the controls
Fan = Adjust fan control
Factory = Reset to factory
Reset settings (without
resetting the user
colours and loops)
UC/ = Resetting user
Loops colours and loops
Reset
Dimmer curves
linear
DMX value
24
RAW
User Cali-
bration
Smart
Calibra.
Factory
Calibra.
On
Off
Auto
Off
Constant
Low
Constant
Medium
Constant
High
ESC
On
Reset
Now?
ESC
Reset User
Colour/
Loops
exponential
DMX value
R, G, B, A and L with maximum value 255
Individual colour calibration. Cross-mode
brightness setting of R, G, B, A and L with
values from 000-255
Merging factory and RAW calibration (cross-
mode)
Factory calibration of R, G, B, A and L (across
all modes)
Automatic locking of the controls after approx-
imately 1 minute of inactivity. After attempted
input the display shows: "Locked!"
Unlock: Simultaneously press the centre and
right encoders for approx. 4 seconds
Automatic locking of the controls is disabled
Automatic fan control
Deactivated fan with greatly reduced bright-
ness
Constantly low fan speed with reduced bright-
ness, if necessary
Constant average fan speed with reduced
brightness, if necessary
Constant high fan speed
Cancel reset with ESC
Reset to factory settings with ENTER (ENTER)
Cancel reset with ESC
Reset to factory settings with ENTER (ENTER)
logarithmic
DMX value
S-curve
DMX value