Display Modes - Wilo CronoLine-IL-E Einbau- Und Betriebsanleitung

8.5

Display modes

Display test
max
min
2
Fig. 33: Display test
8.5.1 Display status page
8.5.2 Display menu mode
"One level down" menu element
"Information" menu element
"One level up" menu element
Installation and operating instructions Wilo-CronoLine-IL-E, CronoTwin-DL-E, CronoBloc-BL-E
As soon as the power supply of the electronic module has been estab-
lished, a 2-second display test is carried out, during which all charac-
ters on the display are shown (Fig. 33). Afterwards the status page is
displayed.
After interruption of the power supply, the electronic module carries
out various shut-off functions. The display will be shown for the
duration of this process.
DANGER! Risk of fatal injury!
There can be electrical charges present in the display even if is
switched off.
• Observe general safety instructions!
The standard view on the display is the status page. The current set-
12.3
point is displayed in the number segments. Other settings are dis-
played using symbols.
NOTICE:
For dual pump operation, the operating mode is also shown in symbol
format on the status page ("Parallel operation" or "Main/reserve").
The display of the slave pump shows "SL".
The electronic module functions can be called via the menu structure.
The menu contains sub-menus on several levels.
The current menu level can be changed using "One level up" or "One
level down" menu items, for example, to change from menu
<4.1.0.0.> to <4.1.1.0>.
The menu structure is similar to structure of the chapters and sections
in these operating instructions: chapter 8.5(.0.0) contains subsec-
tions 8.5.1(.0) and 8.5.2(.0); in the electronics module, menu
<5.3.0.0> contains menu sub-items <5.3.1.0> to <5.3.3.0>, etc.
The currently selected menu element can be identified by the menu
number on the display and the associated symbol.
Within a menu level, menu numbers can be selected sequentially by
turning the operating button.
NOTICE:
If the operating button is not operated for 30 seconds at any position
in menu mode, the display returns to the status page.
Every menu level can contain four different element types:
The "One level down" menu element is indicated on the display by the
symbol shown here (arrow on the units display). If a "One level down"
menu element is selected, pressing the operating button causes a
change to the next menu level down. On the display, the new menu
level is indicated by a menu number that has increased by one digit as
a result of the change; for example, menu <4.1.0.0> changes to menu
<4.1.1.0>.
The "Information" menu element is marked on the display by the sym-
bol shown here (standard symbol for "access disable"). If an "Informa-
tion" menu element is selected, pressing the operating button has no
effect. When an "Information" menu element is selected, current set-
tings or measurements that cannot be changed by the user are dis-
played.
The "One level up" menu element is indicated on the display by the
symbol shown here (arrow on the symbol display). If a "One level up"
English
93