Menu Elements Reference - Wilo CronoLine-IL-E Einbau- Und Betriebsanleitung

English
8.6.8 Termination
8.7

Menu elements reference

No. Designation
1.0.0.0 Setpoint
2.0.0.0 Control mode
98
Disable active
No changes can be made to setpoints or settings. The read access to
all menu elements remains as it was.
Disable inactive
The elements of the basic menu can be edited (menu elements
<1.0.0.0 >, <2.0.0.0> and <3.0.0.0>).
NOTICE:
To edit the sub-elements of menu <5.0.0.0>, service mode must also
be activated.
ON • Reset DIP switch 2 to the OFF position.
The display returns to the status page.
2
NOTICE:
Errors can be acknowledged after a waiting period despite the "access
disable" being active.
In order to establish a definite communication connection between
the electronic modules, it is necessary to terminate both ends of the
cable.
The electronic modules are factory set for twin-head pump commu-
nication and the termination is permanently enabled. No further set-
tings are required.
The following table gives an overview of the available elements of all
menu levels. The menu number and the element type are designated
separately, and the function of the element is explained. If applicable,
there is information about the setting options of the individual ele-
ments.
NOTICE:
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment under menu number
<5.4.1.0> is set to "OFF", the number <5.4.2.0> will be hidden. Menu
number <5.4.2.0> will only be visible if menu number <5.4.1.0> has
been set to "ON".
Type Symbol Values/explanations
±
Setting/display of the setpoint
(for further information, see
chapter 8.6.1 "Adjusting the
setpoint" on page 95)
±
Setting/display of the control
mode
(for further information, see
chapters 6.2 "Control modes" on
page 72 and 9.4 "Setting the
control mode" on page 108)
Constant speed control
Display conditions
WILO SE 08/2022