Acknowledge Fault - Wilo CronoLine-IL-E Einbau- Und Betriebsanleitung

English
11.3

Acknowledge fault

General
6.0.0.0
E000
6.0.0.0
10
1/1
Fig. 47: Navigation in the event of an error
118
E000
5.0.0.0
S
*Error E070; possibly combined with error E073:
If additional signal lines or control cables are connected to the elec-
tronic module, the effects of EMC (immission / interference resist-
ance) may interrupt communication. This results in error code "E070"
being displayed. You can check this by disconnecting all the commu-
nication lines installed by the customer from the electronic module. If
the fault no longer occurs, there could be an external signal interfer-
ing on the communication line(s) that exceeds the applicable stand-
ard values. The pump can only return to normal operation once the
source of interference is remedied.
In the event of an error, the error page is displayed instead of the
status page.
In this case, the following procedure can generally be used for
navigation (Fig. 47):
• To change to the menu mode, press the operating button.
Menu number <6.0.0.0> flashes on the display.
By turning the operating button, it is possible to navigate in the menu
as usual.
• Press the operating button.
Menu number <6.0.0.0> appears steady on the display.
On the units display, the current incidence (x) as well as the maximum
incidence of the error (y) are displayed in the format "x/y".
Until the error can be acknowledged, pressing the operating button
again will cause a return to menu mode.
NOTICE:
A 30-second time-out causes the display to revert to the status page
or error page.
NOTICE:
Each error number has a separate error counter that counts incidences
of the error within the last 24 hours. The error counter is reset after
manual acknowledgement, 24 hours after "Mains on" or after a
repeated "Mains on".
WILO SE 08/2022