Technical Specifications For Operation In Hazardous Areas - Siemens SIPROCESS GA700 Kompaktbetriebsanleitung

Table 10- 40 CALOMAT 7: Gas connections
Gas connections
Connection fittings
Table 10- 41 CALOMAT 7: Parts in contact with sample gases
Materials of wetted parts
Gas connection
Clamping rings and union nut (set)
Sample gas pipes
Sensor mounting block
Sensor
Gasket, contained in the sensor module
10.3

Technical specifications for operation in hazardous areas

The following tables show the data relevant to explosion protection. If the values specified
below deviate from the values of the general technical specifications, the specifications listed
in this section apply.
Compare the specifications in this section with the specifications in the section "General
technical specifications (Page 93)".
Note
Validity of technical specifications
The technical specifications for explosion-proof devices are only valid in combination with the
EC type-examination certificate. The technical specifications listed below are regarded as
general. If these values deviate from those of the EC type-examination certificate, the values
of the EC type-examination certificate apply.
Table 10- 42 Location of use
Location of use
Danger zone
Ambient temperature
Rack-mounted device /
Wall-mounted device
Moisture
Permissible operating height
Also above, after individual check. Contact you Siemens partner for more information, if necessary.
1)
Devices in explosion-proof design
Compact Operating Instructions, 11/2019, A5E35134047-04
10.3 Technical specifications for operation in hazardous areas
Pipe diameter 6 mm (outer diameter)
Stainless steel (Material No. 1.4571)
Stainless steel (Material No. 1.4401)
Stainless steel (Material No. 1.4404)
Stainless steel (Material No. 1.4571)
Si, SiO
Perfluorelastomere FFPM
Zones 1, 2, 22
OXYMAT 7 /
CALOMAT 7
ULTRAMAT 7
No cooling below dew point during storage and operation
2 000 m above sea level
1)
N , Au, epoxy resin, glass
x y
0 to 50 °C
5 °C to 45 °C
Technical specifications
107