Installing The Rack-Mounted Device; Dimension Drawing - Siemens SIPROCESS GA700 Kompaktbetriebsanleitung

4.4.2

Installing the rack-mounted device

Dimension drawing

The following figure shows the dimensions of the rack-mounted device and the distance of
the fastening holes at the mounting brackets. The dimensions are specified in millimeters.
Figure 4-1
Procedure
1. Place the rack unit in the control cabinet or the enclosure.
2. Fasten the rack-mounted device in the control cabinet or enclosure with four screws at its
mounting brackets.
The dimensions for the drill holes are specified in the dimension drawing.
Note
As an option, you can place the rack-mounted device on a guide bracket or floor panel in a
rack or cabinet.
Devices in explosion-proof design
Compact Operating Instructions, 11/2019, A5E35134047-04
Dimension drawing
Installing
4.4 Rack-mounted device
31