Purpose; Field Of Application - Siemens SIPROCESS GA700 Kompaktbetriebsanleitung

Introduction

1.3 Purpose

1.3 Purpose
The device is designed for the concentration analysis of gases in gas mixtures. Depending
on the installed analyzer module, different gases can be examined.
Use the device only for measuring/analysis of gas concentrations in gas mixtures according
to the information in section "Technical specifications (Page 93)".
Note
Aggregate state of examined substances
The system can only be used for gaseous samples.
Note
This device meets the requirements of NAMUR Recommendation 53.
Note
Use in home environment
This equipment of Class A Group 1 is intended solely for use in industrial areas.
If used in homes, the device may cause radio interference.
Note
For more information on the compatibility of the hardware and firmware, refer to:
Siemens Industry Online Support (https://support.industry.siemens.com/cs/de/en/ps/17731).
You will find more information in the operating instructions, see
"References (Page 117)".
1.4

Field of application

These compact operating instructions describe SIPROCESS GA700 devices approved for
operation in hazardous areas. They refer to the rack-mounted and wall-mounted devices
with analyzer modules permanently installed in the factory by the manufacturer that are used
depending on the measuring task and local conditions.
The following analyzer modules are available for explosion-proof devices:
● Standard analyzer modules OXYMAT 7, ULTRAMAT 7 and CALOMAT 7 for rack-
mounted and wall-mounted devices. Up to two analyzer modules possible per basic
device.
● High-temperature analyzer modules OXYMAT 7 and ULTRAMAT 7 only for wall-mounted
devices. Only one analyzer module possible per wall-mounted device.
8
Devices in explosion-proof design
Compact Operating Instructions, 11/2019, A5E35134047-04