Electrostatic Discharge - Siemens SIPROCESS GA700 Kompaktbetriebsanleitung

Safety instructions
2.3 For use in hazardous areas
Note
Open the enclosure only in case of maintenance or service
The enclosure must always remain closed during operation.
• Keep the enclosure closed during operation.
• Open the enclosure only for installation or maintenance. Close the enclosure after this
work has been completed.

Electrostatic discharge

NOTICE
Electrostatic Sensitive Devices (ESD)
Electronic modules contain components that can be destroyed by electrostatic discharge.
These components can easily be destroyed or damaged by electrostatic discharge if not
handled properly.
To avoid damage to property, follow the instructions below.
• Discharge your body electrostatically immediately before touching an electronic module.
• Hold modules only by their plastic enclosure.
• Do not bring electronic modules into contact with electrical insulating material, e.g.
• Place the modules on conductive surfaces only.
• Store and transport electronic modules and components only in ESD-safe conductive
The insulating parts of the high-temperature version of the ULTRAMAT 7 and the keyboard
can be electrostatically charged.
When installing the components, observe the measures against electrostatic charging (ESD
Guidelines) and the standard IEC 60079-0 7.4.2 e).
18
Touch a conductive object, for example a bare metal part of a switch cabinet or the
water pipe.
plastic film, plastic parts, insulating table pads or clothing made of synthetic fibers.
packaging, e.g. metallized plastic containers or metal containers. Leave the module in
the packaging until you install it.
Devices in explosion-proof design
Compact Operating Instructions, 11/2019, A5E35134047-04