Connecting The Signal Cables - Siemens SIPROCESS GA700 Kompaktbetriebsanleitung

Connecting
5.2 Electrical connections
5.2.6.2

Connecting the signal cables

Overview
①
②
③
④
Figure 5-9
Procedure
1. Undo the six screws
2. Remove the shielding plate
3. Strip the end of signal cable to a length of approx. 1 cm.
4. Loosen the union nut from the respective cable gland
mounted device.
56
Screws for door
Shielding plate
Cable glands for signal lines (7 units)
Power supply cable gland
Wall-mounted device, connecting signal cables
①
and open the door of the wall-mounted device.
②
on the right side panel. To do this loosen the screws.
Compact Operating Instructions, 11/2019, A5E35134047-04
③
on the underside of the wall-
Devices in explosion-proof design