Attaching And Removing Sanding Paper; Function Of The Brush Edge; Operation; Connecting To Power Supply - Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise

˜ Attaching and removing
sanding paper
(Fig . J)
Attaching: Align the holes on the sanding
paper with the holes on the sanding
33 ] [
pad . The holes allow the dust to be
2 ] [
extracted from the sanding guard
Press the sanding paper against the sanding
pad . The sanding paper is held in position by
the hook-and-loop fastener .
Removing: Peel off the edge of the sanding
paper . Pull the sanding paper off the
33 ] [
sanding pad .
[ 2 ]
˜ Function of the brush edge
(Fig . J)
The brush edge
7 ] [
sanding pad . The brush edge is the first
2 ] [
part to touch the surface to be sanded . This
allows the sanding pad to be positioned in
parallel to the surface before the sanding
paper touches the surface . This prevents
33 ] [
the formation of sickle-shaped recesses
caused by the edge of the rotating sanding
paper .
The brush edge
[ 7 ]
dust escaping from the sanding guard
Before each use: Check the brush
edge for damages . If the brush edge is
[ 7 ]
damaged or worn out, have it replaced by a
qualified person .
.
1 ] [
protrudes beyond the
prevents excessive sand
.
1 ] [
˜ Operation
˜ Connecting to power supply
NOTES
Before you connect the product to the
u
power supply, make sure that the data on
the rating plate are identical to the power
supply data .
Avoid long supply lines (extension cables) .
u
Do not operate the product in a damp or
u
wet room .
The product may only be operated in
u
suitable rooms (well ventilated) .
Connect the power plug
The product is now ready for use .
˜ Switching on and off
(Fig . K)
Switching on: Press and hold the
trigger .
[ 19 ]
Continuous operation: When the
trigger is pressed down, press the trigger
19 ] [
lock .
18 ] [
Switching off: Release the trigger
you locked the trigger, press it briefly .
to a socket-outlet .
15 ] [
. If
19 ] [
GB/IE/NI 19