Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise Seite 16

15) Do not use accessories that require
liquid coolants. Using water or other
liquid coolants may result in electrocution or
shock .
Further safety instructions for all
operations – Kickback and related
warnings
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, backing pad, brush or
any other accessory . Pinching or snagging causes
rapid stalling of the rotating accessory which in
turn causes the uncontrolled power tool to be
forced in the direction opposite of the accessory's
rotation at the point of the binding .
For example, if an abrasive wheel is snagged or
pinched by the workpiece, the edge of the wheel
that is entering into the pinch point can dig into
the surface of the material causing the wheel to
climb out or kick out . The wheel may either jump
toward or away from the operator, depending on
direction of the wheel's movement at the point of
pinching . Abrasive wheels may also break under
these conditions .
Kickback is the result of power tool misuse and/or
incorrect operating procedures or conditions and
can be avoided by taking proper precautions as
given below .
14 GB/IE/NI
Maintain a firm grip on the power
1)
tool and position your body and
arm to allow you to resist kickback
forces. Always use auxiliary
handle, if provided, for maximum
control over kickback or torque
reaction during start-up. The operator
can control torque reactions or kickback
forces, if proper precautions are taken .
2) Never place your hand near the
rotating accessory. Accessory may
kickback over your hand .
3) Do not position your body in the
area where power tool will move if
kickback occurs. Kickback will propel
the tool in direction opposite to the wheel's
movement at the point of snagging .
4) Use special care when working
corners, sharp edges etc. Avoid
bouncing and snagging the
accessory. Corners, sharp edges or
bouncing have a tendency to snag the
rotating accessory and cause loss of control
or kickback .
5) Do not attach a saw chain
woodcarving blade or toothed
saw blade. Such blades create frequent
kickback and loss of control .