Safety Warnings Specific For Sanding Operations; Additional Safety Instructions; Vibration And Noise Reduction; Remaining Risks - Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise

˜ Safety warnings specific for
sanding operations
Do not use excessively oversized
1)
sanding disc paper. Follow
manufacturers recommendations,
when selecting sanding
paper. Larger sanding paper extending
beyond the sanding pad presents a
laceration hazard and may cause snagging,
tearing of the disc or kickback .
˜ Additional safety instructions
Connect a vacuum cleaner to the
1)
supplied adapter before starting
your operations.
2) Attention! Keep away sanding dust from
open fire . Dust may be explosive .
3) Always wear goggles and a dust
mask when sanding, in particular
during overhead work and when
processing critical materials! When
sanding certain materials (e . g . lead paint,
certain types of wood and metal) harmful or
noxious dust may be generated . Touching or
breathing in such dust may imply risks for the
operator or bystanders .
˜ Vibration and noise reduction
To reduce the impact of noise and vibration
emission, follow below steps:
1 . Only use power tools which are free of
defects .
2 . Maintain and clean the power tool on a
regular basis .
3 . Adjust your way of working to the power tool .
4 . Do not overload your power tool .
5 . Have your power tool inspected, if necessary .
6 . Switch off the power tool when it is not in use .
˜ Remaining risks
Even if you use this power tool in compliance with
the regulations, there are still remaining risks . The
following risks may occur due to the type and
design of the power tool:
Damage caused to your health resulting from
hand/arm vibrations if the power tool is used
over a longer period of time or if it is not
properly used and maintained .
Injury and damage to property caused by
flying off sanding paper or any loose parts
from the running power tool which are
unexpectedly expelled from the power tool
due to sudden damage, wear or incorrect
insertion .
Burns and cuts if the insertion tools are
touched directly after use and/or with bare
hands .
GB/IE/NI 15